Page 196 - 8170 Money Builder Binder for Owner_Neat
P. 196

INSTALLATION




                   Turn the cold water supply          Disconnect the water pipes.          Install a suitable drain pan
              7    valve OFF.                    11    Many water pipes are            2    that is piped to an adequate

                                                       connected by a threaded              drain.
                   Open the drain valve on the   union which can be disconnected with
              8    water heater.                wrenches. If you must cut the water         Set the water heater in place
                                                pipes, cut the pipes close to the water   3  taking care not to damage
                                                heater’s inlet and outlet connecƟ ons,      the drain pan.
                                                leaving the water pipes as long as
                                                possible. If necessary, you can make   NOTICE: Most codes require seƫ  ng
                                                them shorter later when you install   the water heater in a suitable drain
                                                the new water heater.                pan piped to an adequate drain. The
                                                                                     drain pan helps avoid property dam-
                                                 12    Remove the old water heater.  age which may occur from condensa-
                                                                                     Ɵ on or leaks in the piping connecƟ ons
            Figure 10 -രDraining the old water heater.                               or tank. The drain pan must be at
                                                   WARNING! Use two or more people   least two inches wider than the diam-
                   Also open a hot water faucet
              9    to help the water in the tank   to remove or install water heater.   eter of the water heater.  Install the
                                                Failure to do so can result in back or
                   drain faster.                                                     drain pan so the water level is limited
                                                other injury.
                   When the tank is empty,       Step 4:                             to a maximum depth of 1-3/4”.
       INSTALLATION  discharge pipe. You may be able to   Installing the new         •  The T&P Relief Valve will not be in
             10
                   disconnect the Temperature &
                                                                                            Verify that the water heater
                   Pressure (T&P) Relief Valve
                                                                                       4
                                                                                            is properly set in place. Check
                                                                                            that:
                                                water heater
            reuse the discharge pipe, but do not
            reuse the old T&P Relief Valve.  A new
                                                                                       contact with any electrical parts.
                                                       Completely read all instruc-
            T&P Relief Valve comes installed on
            your water heater (or on some models,
                                                       are not sure if you can
                                                                                       the T&P Relief Valve discharge pipe
            is in the carton with the water heater).   1  Ɵ ons before beginning. If you   •  There is adequate space to install
                                                complete the installaƟ on, DO NOT      and that it can be piped to a sepa-
                                                RETURN THIS UNIT TO THE STORE.         rate drain (and not into the drain
                                                                                       pan).
                                                Seek assistance from any of the
                                                following sources:                   •  There is adequate access and space
                                                •   Schedule an appointment with       around the water heater for future
                                                  a qualified person to install your   maintenance.
                                                  water heater.
                                                •  Call our Technical Assistance Hot-
                                                  line at    1-800-821-2017

            Figure 11 -രRemoving the T&P Relief Valve
            discharge pipe.














             10 • ResidenƟ al Electric Water Heater Use and Care Guide
   191   192   193   194   195   196   197   198   199   200   201