Page 200 - METRO CENTER PDF BINDER 1

RECESSED T-BAR MOUNTING INSTALLATION GUIDE (T/X/N)

1 D 2

C

B

C
C
A
1
A

B

3 A 4
D/G JOINER

C
A
N = 9/16” SLOT T = 9/16” + 1/2” X = 15/16” + 1”
ACL1/4 JOINER

B
B

C
ACL2/3/5 JOINER
INSTALLATION STEPS

Attention: Risk of fire and electrical shock - fixture to be installed by qualified electrician according to local codes and ordinances.
Attention: Ensure proper handling of LEDs to limit common problems including: broken connection, loose wiring, and damage from electrostatic discharge.
1 [A] - Install T-bar, keeping in mind the spacing dimensions provided in the chart below. Consult 2 ROWS
[A] - When rows are ordered, row sections will be labeled in sequence. Position section in proper
submittal drawings if modified lengths were ordered.
[B] - Powerfeed connections through KO hole: White+, Black-, Green (if dimming is required): Purple Dim+, order prior to installation (ie place 1 to 1).
Grey Dim- [B] - Remove the lens. Apply suction cup (provided) to one end and carefully pull lens out.
[C] - Flanges should sit on top of t-bar surface, as per the profile diagrams. [C] - Remove reflectors (if applicable) and internal gear tray by unfastening hardware.
[D] - Attach tie-off cables to tie-off holes on fixture end caps and attach each end to structure above as
per local code. 3 [A] - Housing connection: White+, Black-, Green (if dimming is required): Purple Dim+, Grey Dim-
ON-CENTER DIMENSIONS: [B] - Align corner pins and connect fixture housings with rubber mallet until no gap remains.
[C] - Secure sections with joiner screws.
T-BAR T N X T4 N4 T6 N6
ON-CENTER ACL 2-7/8” 2-7/8” 3-7/32” 4 [A] - Reinstall reflectors (if applicable) and internal gear tray. Install lamps (by others, if applicable).
[B] - Reinstall lens.
WIDTHS D5/D7 4-5/32” 4-5/32” 4-1/2” 4” 4”
D6 6” 6” 6”
G 5-11/16” 5-11/16” 6” 6” 6”
ON-CENTER LENGTH 24”, 36”, 48”, 60”, 72”, 84”, 96”, 108”, 120”, 144”
APPLICABLE LUMINAIRES: ACL5, ACL7, D5, D6, D7, G5