Page 202 - METRO CENTER PDF BINDER 1

RECESSED TRIM FLANGE MOUNTING INSTALLATION GUIDE (XP)

1 2

C

OPTION 01
A

C
A
1

B
B

A
OPTION 02 3 4
D/G JOINER

A

C
A

ACL1/4 JOINER

B B
B

C
ACL2/3/5 JOINER
INSTALLATION STEPS

Attention: Risk of fire and electrical shock - fixture to be installed by qualified electrician according to local codes and ordinances.
Attention: Ensure proper handling of LEDs to limit common problems including: broken connection, loose wiring, and damage from electrostatic discharge.
1 [A] - Cut opening in ceiling. For nominal lengths, reference dimensions in chart below, or consult submittal drawings 2 ROWS
for special lengths cut-outs.
[A] - When rows are ordered, row sections will be labeled in sequence. Position section in proper
[B] - Option 01 - Apply clamp above each top-hole section twisting into rough opening. Tighten 1/4-20 bolt (provided) order prior to installation.
to press together panels in between fixture flange and clamp flange. The bolts are to be tied to structure and if not [B] - Remove the lens. Apply suction cup (provided) to one end and carefully pull lens out.
tie-off cables at each end cap must be attached to structure above. [C] - Remove reflectors (if applicable) and internal gear tray by unfastening hardware.
Option 02 - Use pre-drilled holes in top of fixture to attach 1/4-20 threaded rod (provided by others) and tie to
structure. Draw fixture up snugly under bottom of ceiling slates/tiles and fasten with a flange nut. [A] - Housing connection: White+, Black-, Green (if dimming is required): Purple Dim+, Grey Dim-
[C] - Power feed connections through KO hole: White+, Black-, Green (if dimming is required): Purple Dim+, Grey Dim- 3 [B] - Align corner pins and connect fixture housings with rubber mallet until no gap remains.
[C] - Secure sections with joiner screws.
NOMINAL ROUGH OPENING DIMENSIONS:
NOMINAL LENGTH 12FT 10FT 8FT 6FT 4FT 2FT 4 [A] - Reinstall reflectors (if applicable) and internal gear tray. Install lamps (by others, if applicable).
ROUGH OPENING 138.25” 115.00” 92.00” 69.25” 46.25” 23.25” [B] - Reinstall lens.
LENGTH
ROUGH OPENING
WIDTH (ACL) 2.50” - 2.63”, (D) 3.75” - 4.00”, (G) 5.25” - 5.50”
APPLICABLE LUMINAIRES: ACL5, ACL7, D5, D7, G5