Page 418 - Installation Training Binder FIT1-3
P. 418
5. Pull liner into clear and clean workspace
6. Lay liner flat and remove all wrinkles
7. Measure width of stanchions
8. Note any inconsistency between stanchions
Parallel
Exact measurement
9. Extend stanchion lines entire width of liner (Figure 10)
10. Repeat for all stanchions
11. Verify lines are parallel (Figure 11)
Figure 10 Figure 11
12. Measure width of liner
13. Strike centerline half the width on liner (Figure 12)
14. Measure and transfer to liner
Jogs
Abutments
Obstructions
15. Measure length of stanchions
16. Mark each side of liner half the length from the centerline (Figure 13)
Figure 12 Figure 13
EnviroGuard 800-206-9884 Fax 909-624-1772 www.egsintl.com
10/08 rev. A Hawk System Retrofit Installation Setup Instruction - 5 -
