Page 995 - CRESTRON HOME OS-3

4. On the DEVICE ADDRESS screen, program address 25:

a. Press 25 and then * to program device address 25.
b. Press 12 to set the device type to Remote Interactive Service (RIS).
c. Press * to return to the DEVICE ADDRESS screen.
5. On the DEVICE ADDRESS screen, program address 5:
a. Press 05 and then * to program address 5.

b. Press 01 and then * to set the device type to Alpha Keypad.
c. Press 1 and then * to assign the device to Partition 1.
d. Press * until AUI ? is displayed on the screen. Press 1 and then * to set the device as a
graphic/touch-screen keypad and return to the DEVICE ADDRESS screen.
6. On the DEVICE ADDRESS screen, program address 6:
a. Press 06 and then * to program address 6.

b. Press 01 and then * to set the device type to Alpha Keypad.
c. Press 1 and then * to assign the device to Partition 1.
d. Press * until AUI ? is displayed on the screen. Press 1 and then * to set the device as a
graphic/touch-screen keypad and return to the DEVICE ADDRESS screen.
e. Press 00* then press 1 to exit the DEVICE ADDRESS screen.
7. Press *99 to exit Device Programming mode. After the system resets, it will be ready for
use with the Crestron Home system.
Set the Keypad Address

NOTE: The Crestron Home system communicates with the security system over address 1 and
17 for commercial installations and 5 and 6 for residential installations. Do not assign a keypad
to address 1 and 17 for commercial installations and 5 and 6 for residential installations.

1. Power up the keypad and (within 60 seconds) press and hold the 1 and 3 keys at the same
time for 3 seconds. The keypad enters Address mode.
2. Enter the two digit keypads address for the keypad.

NOTE: The first keypad address is 16.

3. Press * to save the keypad address and exit Address mode.

978 • Crestron Home™ OS Product Manual — Doc. 8525Z