Page 655 - Med Plaza and Cancer Center

PROPRIETARY AND CONFIDENTIAL DRAFT 28/Feb/03

Master Alarm Labeling
Chapter 1: Introduction

Figure 1-18. Master Alarm Labeling

SHOCK HAZARD:
Turn off the power to the alarm, and leave it off during the installation of
any component or sub-assembly. Failure to do so could result in
personal injury or equipment damage.

3. Turn the power switch (CB) to the OFF position.

4. Stick the appropriate labels (BX) to the front side of the label strip (BY)
(see table 1-28 on page 1-57).

5. Locate and remove the label strips (BY) from the openings (BZ).

NOTE:
More label strips are supplied with the Master Alarm, if needed.

The label strips read from left to right with “IN” on the left-hand side, and
“OUT” on the right-hand side.

6. Starting with the word “IN,” slide the label strip (BY) into the label
opening (BZ) with the words facing away from the rough-in assembly
(CC).

Page 1 - 58 MedPlus TotalAlert™ Alarm Network Operation and Maintenance Manual (man291ra)