Page 720 - Med Plaza and Cancer Center

PROPRIETARY AND CONFIDENTIAL DRAFT 28/Feb/03

Configuring the Area Alarm by Using the Front Panel
1
Chapter 1: Introduction

. This is the zone that the module is monitoring. It can be
10. Configure 2onE
.
from 1 through 9999
. This displays the units of measure. The units of measure are
11. View ScAL
as follows:

• PSi is pounds per square inch.

• hPAS is kilopascals.

• inhG is inches of mercury.

• nnhG is millimeters of mercury.

NOTE:
The units of measure cannot be changed.

12. Configure dFLt .

CAUTION:
The default command sets the Area Alarm Module back to the factory
defaults. If you do not want the factory default values, choose no .
Otherwise, the alarm may not operate as intended.

This option sets the Area Alarm Module back to the factory values.

• no keeps the current configuration.

• YES sets the configuration back to the factory default values.

. This is the firmware revision for the transducer.
13. View rEu
t
. This is the firmware revision for the Area Alarm Module.
A
14. View rEu

MedPlus TotalAlert™ Alarm Network Operation and Maintenance Manual (man291ra) Page 1 - 123