Page 821 - Med Plaza and Cancer Center
P. 821

PROPRIETARY AND CONFIDENTIAL DRAFT 28/Feb/03

                   4.7  Area Alarm Breakout P.C. Board
                   Chapter 4: Removal, Replacement, and Adjustment Procedures

                   4.7    Area Alarm Breakout P.C. Board

                                 Tools required:   Phillips head screwdriver
                                                   5/32" hex wrench
                                                   Needle nose pliers

                          Removal


                                 1. Using a 5/32" hex wrench, unlock the front panel (A) (see figure 4-8 on
                                     page 4-22).


                                         Figure 4-8. Area Alarm Breakout P.C. Board








































                                 SHOCK HAZARD:
                                 Turn off the power supply in the alarm, and leave it off during the
                                 installation or replacement of any component or sub-assembly. Failure
                                 to do so could result in personal injury or equipment damage.

                                 2. Turn the power switch (H) to the OFF position.

                                 3. Push open the ears of the connectors (E) to remove the ribbon cable (B).







                   Page 4 - 22           MedPlus TotalAlert™ Alarm Network Operation and Maintenance Manual (man291ra)
   816   817   818   819   820   821   822   823   824   825   826