Page 823 - Med Plaza and Cancer Center
P. 823
PROPRIETARY AND CONFIDENTIAL DRAFT 28/Feb/03
4.8 Area Alarm Connector P.C. Board or Network Communications Board
Chapter 4: Removal, Replacement, and Adjustment Procedures
4.8 Area Alarm Connector P.C. Board or Network
Communications Board
Tools required: 5/32" hex wrench
Removal
1. Using a 5/32" hex wrench, unlock the front panel (A) (see figure 4-9 on
page 4-24).
Figure 4-9. Area Alarm Connector P.C. Board or Network Communications Board
SHOCK HAZARD:
Turn off the power supply in the alarm, and leave it off during the
installation or replacement of any component or sub-assembly. Failure
to do so could result in personal injury or equipment damage.
2. Turn the power switch (H) to the OFF position.
The Area Alarm has either a Connector P.C. Board (D) or a Network
Communications Board (E) mounted to the back of the front panel (A).
Page 4 - 24 MedPlus TotalAlert™ Alarm Network Operation and Maintenance Manual (man291ra)
