Page 230 - Womens Pavilion

“Oil-Less” Scroll Medical Air

Appendix B: Dew Point Transmitter

B.7 Troubleshooting Before servicing the dew point transmitter, do the
following:

WARNING:
1. Close dew point transmitter isolation valve
Before removing the dew point 2. Allow transmitter piping to depressurize
transmitter, verify that line pressure has through the fl owmeter until it reduces to
been valved off or reduced to atmospheric atmospheric pressure.
pressure.
3. Disconnect sensor cable and remove
transmitter from piping.

NOTE: Remote alarms will be activated

Problem Possible Cause Solution
Slow system response Insuffi cient fl ow through dew Check fl ow
point sensor

No power No incoming power Verify line power is being supplied

Erratic display Unit defect Contact BeaconMedæs

High dew point Air is not being dried Verify that the online dryer (valve
open) is in the “Automatic” position
on the control panel and that the
off -line dryer (valve closed) is in the
“Off ” position on the control panel.

Check fl ow

Faulty sensor Replace sensor

B-3 4107 9000 69.06