Page 188 - 2018 Allstar Performance Parts and Equipment Catalog

SUSPENSION Hydraulic 2-1/2" Coil-Over Weld-On Shock Brackets

Weld-on shock brackets mount standard and coil-over
Spring Adjuster ALL64220
shocks with 1/2" I.D. inner bushing or 1/2" rod end to
Weight jack assembly allows
chassis as well as many other uses. 1/8" thick mild steel
driver to adjust car handling
while driving. Turning the
adjustment knob will extend
spring cup up to 7/8" to increase or brackets include 1/2" bolt, spacer and locknut.
decrease spring pressure. Assembly Notched Tube Mount
includes hydraulic ram, hydraulic Bracket is notched for 1-1/2" - 1-3/4" round tubing to
pump with adjustment knob, 9' create a gusset style mount that welds on three sides.
braided hose, and two washers for use with Notched design positions the bracket perpendicular to
standard or threaded body shocks. Black the tubing at a 90 degree angle for straight mount and
anodized finish. approximately a 75 degree angle for angled mounts.
Replacement Part
ALL64222 ..... O-Ring Kit For ALL64220 Straight Mount
Coil-Over Eliminator ALL64100
Eliminator fits conventional 5" coil springs.
Adjuster locks spring into place. Kit includes a ALL60103 ALL60104 ALL60112
threaded shaft, two spring plates, one adjuster,
two rod ends and two jam nuts. Easily adjusted ALL60103 ..... Short Single
with ALL11146 wrench. Not to be used as a ALL60104 ..... Long Single
suspension limiting device, check maximum ALL60112 ..... Long Two Position
travel before use. ALL60113 ..... Extra Long Three Position ALL60113

Angle Mount
Shock Spacers
Steel spacers have a 1/2" I.D. and 3/4" O.D. and can be
used in a variety of other locations.

Length 2-Pack 10-Pack ALL60100 ALL60101
1/4" ALL64280 ALL64280-10
1/2" ALL64282 ALL64282-10 ALL60100 ..... Left Hand Single
5/8" ALL64283 ALL64283-10 ALL60101 ..... Right Hand Single
3/4" ALL64284 ALL64284-10
Shock Extensions Round Tube Mount
Steel extensions fasten directly to shock shaft for
added suspension travel. Sold each. Bracket welds parallel onto
tubing. Typically mounted
M12-1.0 Thread (Bilstein) above or below tubing and
ALL60096..... 1" Extension includes 1/2" shock mounting ALL60107 ALL60114
ALL60097 ..... 2" Extension hardware. Mounting positions
7/16"-20 Thread (Fox) are on 1" centers.
ALL60098..... 1" Extension ALL60107 ..... Single
ALL60099 ..... 2" Extension ALL60114 ..... Two Position
ALL60115 ..... Three Position
Shock Racks ALL60115
Shock rack holds four
shocks with 2-1/2" Flat Mount
springs and easily Bracket mounts to a flat surface or
mounts to trailer, shop square tubing.
wall or pit cart. Rack is designed
to hold shocks in place by pushing shock ALL60106 ..... Single ALL60106
rod end or eye over the outer O-ring or alterna- Related Parts
tively, the outer O-ring may be removed to expose ALL12211 ALL99100 ..... Replacement bolt, locknut, and bushing
a predrilled hole for a hair pin clip such as ALL18442 ALL99101 ..... Replacement bushing only
which are sold separately.
ALL12212 ...... Standard Rack
ALL12211 ...... Adjustable Base Rack
186 www.allstarperformance.com