Page 552 - Chief Architect Reference Manual
P. 552

Chief Architect X10 Reference Manual



                        • Click the Clear button to remove a     2  Check Use Exterior Lintel to enable
                           selected lintel profile from the door.   the settings that follow, then specify the
                        • Specify the Width of the lintel. This   exterior lintel for the selected door(s) using
                           value is independent of the casing’s   these settings. These settings are the same as
                           width; however, the lintel does inherit its   those for the Interior Lintel, and are not
                           depth from the casing.               available for doors in interior walls unless
                                                                Use Exterior Trim and Materials is checked
                        • Specify how far to Extend the lintel past   on the GENERAL panel. See “General Panel”
                           the outside edges of the casing on each   on page 545.
                           side.
                        • Check Wrap to wrap the lintel profile   3  A preview of the door displays on the
                                                                    right side of the dialog box. See
                           back toward the wall.
                                                                “Dialog Preview Panes” on page 42.
                                                        Lites Panel
                        The settings on the LITES panel of the Door   also found on the LITES panel of the Window
                        Specification dialogs are only available   Specification dialog. See “Lites Panel” on
                        when the selected door is specified as a Glass   page 588.
                        door on the General Panel. These settings are

                                                       Jamb Panel
                        The settings on the JAMB panel are only   those on the FRAME panel of the Window
                        available when casing is specified on the   Specification dialog. See “Frame Panel” on
                        Casing Panel. These settings are similar to   page 586.




























                   552
   547   548   549   550   551   552   553   554   555   556   557