Page 550 - Chief Architect Reference Manual

Chief Architect X10 Reference Manual

1 Check Use Interior Casing to enable The opening on the other wall is enlarged
the settings that follow, then specify the to accommodate the casing.
interior casing for the selected door(s) using • Select Double to place a second door in
those settings. When this box is unchecked, the Double Wall opposite the selected
no casing is used. door. This second door cannot be
• Casing Profile - Click the Library but- selected. Casing is produced as with the
ton to select a molding profile for the cas- Through type window.
ing. A preview of the casing profile • Select Not Through to place the door in
displays to the right. See “Select Library one wall with no corresponding opening
Object Dialog” on page 940. in the other wall.
• Click the Clear button to remove a The Curved Wall Casing settings are
selected casing profile from the door. 5
enabled if the selected door is located in
• Specify the Width of the selected casing. a curved wall. See “Drawing Curved Walls”
• Define the Depth of the selected casing, on page 359.
as measured from the back to the front of Door and window casing and jamb can be
the casing profile. constructed three ways in curved walls:
• Define the Reveal, which is the distance • Straight - Both the door and casing are
between the inside edge of the door frame straight. This can be used where the wall’s
and the inside edge of the casing. curvature is not too sharp and the opening

2 Check Use Exterior Casing to enable is not too wide. It cannot be selected for
the settings that follow, then specify the Pocket Doors, which must be curved if
exterior casing for the selected door(s) These placed in a curved wall.
settings are the same as those for the Interior
Casing, and are not available for doors in
interior walls unless Use Exterior Trim and
Materials is checked on the GENERAL panel.
See “General Panel” on page 545. Straight

3 Uncheck Use Sill/Threshold to prevent • Radial - A vertical surface that would be
a sill from being generated under the
door. See “Displaying Doors” on page 535. perpendicular to a straight wall has its
plane pass through the wall's center of
4 The Double Wall Options affect doors curvature.
placed in a Double Wall. See “Double
Walls” on page 380.
• Select Through to create a single jamb
running through both Double Walls. This
option is selected by default. Radial
•If Enlarged is selected, casing is created
only on the wall the door is inserted in.

550