Page 548 - Chief Architect Reference Manual
P. 548

Chief Architect X10 Reference Manual



                        • Select Automatic to display wall surface   6  The Safety settings afffect how the
                           lines only when the selected door is a   selected door is listed in the Door
                           Doorway.                             Schedule. See “Schedules and Object
                        • Select Show Top Edge to display wall   Labels” on page 667.
                           surface lines regardless of the door type.  • Check Tempered Glass to specify the
                        • Select Hide Top Edge to not show wall   selected door as having tempered glass.
                           surface lines regardless of door type.  • Check Fire Door to specify the selected
                                                                  door as being a fire door.
                         3  3D Display - Specify whether the
                            selected door is shown open or closed   7  The Recessed into Wall options allow
                        in 3D and cross section/elevation views.    you to recess the selected door’s jamb
                                                                into a wall, away from the exterior surface.
                        If Show Open is selected, the Swing Angle   This setting also affects the exterior casing
                        set on the General Panel is used.
                                                                and lintel, if used. Only available if the door
                         4  Door Swing - Specify how the selected   is placed in a multi-layered wall. See “Wall
                            door swings. Most options here are   Type Definitions” on page 383.
                        only available when the selected Hinged or
                        Pocket door is a Double Door. Not available
                        for Bifold, Slider or Garage doors. See
                        “Changing Door Swings” on page 539.
                        • Check Both Doors Swing to allow both               Not Recessed
                           sides of a Double Door to swing.
                        • Check Left Swing Only or Right Swing
                           Only to allow only the left or right side of
                           a Double Door to swing.
                                                                         Recessed to Main Layer
                        • Check Swings from Center to create a
                           Double Door with hinges at the center
                           rather than at the outside edges.
                        • Check Swings Both Directions to allow a
                           door or both sides of a Double Door to       Recessed to Sheathing Layer
                           swing both directions.
                                                                • Check Recessed to activate the settings
                         5  For a selected Garage Door, specify   that follow.
                            the number of Vertical Panels.
                                                                • Select To Main Layer to recess the door
                        • If the selected door has been specified as   to the wall’s Main Layer.
                           the “Glass” Door Type on the GENERAL
                           panel, the top Vertical Panel will be glass   • Select To Sheathing Layer to recess the
                           and the rest, solid panels. The number and   door to the wall’s sheathing layer.
                           style of the lites and the Muntin Width   In Curved Wall - Specify whether a
                           can be specified on the LITES panel.  8  door placed in a curved wall is Straight




                   548
   543   544   545   546   547   548   549   550   551   552   553