Page 102 - FreesStyler® Installation and Startup

®
INSTALLATION AND STARTUP

Chapter 5 Entrance and Exit Photo-Eyes

Photo-Eye Layout and Description

Two sets of Photo-Eyes will typically cover all FressStyler® functions and options.
More sets can be added to the system in the case where a customer desires precise on/off timing for
particular components such as a free-standing Pre-Soak or other out-board free-standing pieces of
equipment. The system can accommodate up to 5 sets total (3 sets at the entrance and 2 sets at the
exit).

Before installing any of the Photo-Eyes, read and understand the Entrance Operations and
Exit Operations sections from the FressStyler® Programming Manual.

The image below shows the “zones” that are assigned to a two Photo-Eye set system.

Exit Direction of Travel Entrance
Photo-Eye Photo-Eye
Zone Zone

The “Entrance Zone” is typically between the entrance Photo-Eyes and just after the treadle.
Equipment in this zone typically turned on with the Photo-Eye, and then turned off by either the
Photo-Eye or the Treadle even though other on/off options are available.

The “Exit Zone” is typically between the Treadle and the exit door Photo-Eyes. Equipment in this
zone is typically turned on at END OF CYCLE and then turned off when past the Photo-Eyes. Many
other on/off options are available.

The actual installation of the Photo-Eyes is covered later in this document.

5-2 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL220