Page 109 - FreesStyler® Installation and Startup

®
INSTALLATION AND STARTUP

Chapter 5 VPS® Photo-Eye

VPS® Photo-Eye Signage

Available Options
Part Number Description

1SIGN-FS030 FressStyler® Inbay Sign with Swivel Mount
1SIGN-FS035 FressStyler® Inbay Sign with Pedestal Mount

Overview
If you have purchased the VPS® option for your FressStyler®
machine, it is necessary to order one of the signs that are listed in
the table above. The purpose of the sign is to assist the carwash
customer with navigating through the bay at the right times.

Note: This optional sign is an addition to the factory installed on-
board sign.

Installation
There are two different ways to mount the sign in the bay. A
pedestal mount and a wall mounted swivel. Which ever one is
selected, the sign will need to be mounted on the passenger side
of bay close to the dryer system. See the images below for more
details.
1) Locate the skid that the sign was shipped on. Inspect for any
damages at this time.
2) Remove the sign from the skid.
3) Jog the FressStyler® machine until it is at the exit positive
stops at the end of the rails. Turn the passenger side exit
wheel arm on so that it is spinning and then fire the arm out.
4) Position the sign on the passenger side of the bay, close to
the dryer system, making sure that it is clearly visible for the
customer to see when the car wash is running.
5) Take note of the furthest point the NeoTex reaches and allow
room between the sign and the measured point. This is to
assure that the arm will never come in contact with the sign.
6) Mount the sign using field supplied fasteners.

7) Have a certified field electrician wire up the optional sign to the same outputs that the on-
board sign is wired too.
8) Run a few test washes to insure that everything is working properly and that the sign is
visible.

1MANUL220 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 5-9