Page 181 - FreesStyler® Installation and Startup

®
INSTALLATION AND STARTUP

Chapter 9 Optional “Add-On” Items

Wheel Cleaning and CTA Options

Hockey Puck Installation
Before you tighten the Hockey Pucks down refer to the detailed picture on how they should all be aligned.
Notice on the face of the Hockey Pucks there are 2 sets of 2 lines and 2 sets of single lines. All of the single
lines need to be lined up in a vertical position. The middle Hockey Puck assembly should have its single
(vertical) lines on the opposite side of center when compared to the other two as hi-lighted below.

Vertical lines to left

Vertical lines to right

Vertical lines to left

1) When all three Hockey Puck assemblies have been tightened in, the spray nozzle holes should be aligned
like this:
• The top and bottom Hockey Puck assemblies should have 3 nozzles to the right of the single line and 2 nozzles to
the left of the single line.
• The middle Hockey Puck assembly should have 3 nozzles to the left of the single line and 2 nozzles to the right of
the single line.
2) Tighten in all of the spray nozzles. Only apply liquid Teflon™ to the threads of the nozzles. Make sure not to
get any inside of the nozzle as this may cause it to plug the hole up.

1MANUL220 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 9-49