Page 186 - FreesStyler® Installation and Startup

®
INSTALLATION AND STARTUP

Chapter 9 Optional “Add-On” Items

HydroBlade® Option

Installation
1) Shut off and lock out any power supply to the FressStyler®.
2) Open the Side Pod Cover on both sides.
3) Remove the two Wheel Cleaner/HydroBlade® Side Manifolds from their
packaging as shown in side image.
4) Notice on the passenger side manifold there is a Tee mounted to the upper
mount plate. The driver side does not have this Tee as shown below.

Passenger
Side has a Tee

5) Remove the four 1/2-13 x 2’’ fasteners and lock washers from the Upper Mount
Plate as shown below (typical).

6) Position the Upper Mount Plate inside of the side pod as shown above. Notice
the Upper Mount Plate mounts inside the side pod and the bolts tighten thru the bottom of the side pod plate.
Be sure to mount the driver side and passenger side in the correct location.

Upper Mount Plate

Once the side manifolds have been mounted to the machine it is time to hook up all of the high pressure
water lines onto the machine. There are seven high pressure lines to run not including the line that will run
thru the boom.

9-54 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL220