Page 36 - FreesStyler® Installation and Startup

®
INSTALLATION AND STARTUP

Chapter 3 Getting Started

FressStyler® Position Considerations

Note: Using the previously stated considerations and the site overview, determine at your site if the
machine needs to be put off-center of the doors, and/or if either side arms will need to be de-stroked
to maintain clearance. Record the information below.

Considering the length, width and height issues previously discussed, answer the following
questions.
Summary of Width Considerations Record Here
D From centerline of door to the passenger side wall
E From centerline of door to the driver side wall
I will need to de-stroke the passenger side arm YES NO
I will need to de-stroke the driver side arm YES NO
I would like to align the center of the rails to the center of the doors YES NO
If not, shift the center of the rails towards the…. Driver side Passenger side How Far (inches)

Summary of Length Considerations Record Here
What is the maximum length vehicle you plan to wash?
4 Legged Frame: Treadle and vehicle should be set to factory spec of 9” behind entrance YES NO
side of exit 4 x 6 leg
6 Legged Frame: Treadle and vehicle should be set to factory spec of 49” behind entrance YES NO
side of exit 4 x 6 leg
If no, will I move the Treadle forward (toward the exit)? YES NO How Far (inches)
Will I have to move the End Limit Stop? YES NO How Far (inches)
Will I need “Small Bay” software? YES NO

Using the above length consideration and the two layout drawings, determine the exit leg position in
the bay.

Note: The head beams are 190” long and made for buildings 16’ (192”) or greater. If D + E is less
than 192” in the area of the head beams, they must be cut to a length 2” shorter than D + E.

3-12 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL220