Page 13 - Tire Washer

TIRE WASHER

Installation

Assembly

1) Lag through elongated slot ONLY. Level the unit by inserting the supplied leveling bolt through the
threaded hole of the floor plate. Tighten lag bolt until snug.
2) Move the brush back and forth through its full range of motion to insure proper clearance.
3) Once you are sure the Tire Washer will move through its full range of motion without obstruction and it
is level, lag unit to the floor securely.
4) Position the passenger side Tire Washer assembly in its appropriate tunnel location.
5) Level it and lag it to the floor.
6) Remove the steel shipping crossbeam from each assembly

Shipping beam (typical)

7) Locate the height adjusting bolts at the rear of the support legs.

Leveling bolts for
cylinder height
adjustment
(typical)

Leveling bolts for
cylinder height
adjustment
(typical)

1MANUL738 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 11