Page 191 - Saber® Installation & Startup

INSTALLATION & STARTUP

Chapter 15 MixStir® Options

High Pressure Wax Option #2
9. Locate the supplied 1/4” x 7 foot clear chemical feed and run from the barbed fitting on the E-gap Eductor
to the field supplied chemical drum making sure there is a siphoning filter on the end of the hose (in the
drum). You will have to remove this hose during the startup procedure after confirming chemical
dilution requirements.

E-Gap
Eductor

10. Connect a city water feed to the main water inlet as shown below.

City Water Supply

11. Connect the wax solenoid cable to the SDM Electrical Distribution Block as shown below.
SDM This image Dual plug feed for
Electrical
Distribution shown with the Sealer Wax option
Block Low Pressure
(dual) plug. The
optional High SDM Electrical
Pressure (single) Distribution
Block
plug will go here
in its place

12. On the Output Board in the MCC, swap the wires for outputs 13 and 14.
13. Program a Sealer Wax pass with a pump speed of 25% to run a low-pressure wax using the standard
Pulsatron™ pump.
14. For a medium pressure (both arms), program the wax pass with a pump speed of 26-100%. This will use
the MixStir® high-pressure wax option and come out of both arms. For a high-pressure pass (1100 PSI,
one arm at a time), see “Application Configuration” in your Saber® Programming Manual. This will also
use the MixStir® High-Pressure Wax Option and come out of one arm at a time.
This type of pass is used often on an inexpensive base package, to apply presoak, and then rinse and
wax quickly.
In this configuration Drying Agent is using the MixStir® and the Sealer Wax is using an additional
Pulsatron™ pump.

1MANUL290 Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 15-7