Page 26 - Quad Wave Mitter Signature® Series
P. 26

QUAD WAVE MITTER Signature ® Series


             Maintenance

             Routine Procedures

                Monthly
                    Wash component down with a good degrimer such as Tide laundry detergent and hot water.
                Quarterly
                    Scrub down aluminum portions of the component with a fine steel wool such as S.O.S. pads
                     and  wash  with  good  degrimer  such  as  Tide  laundry  detergent  and  hot  water  (whenever
                     using steel wool on aluminum, always follow the grain to prevent scratching the finish).
                Semi-Annually
                    There  is  a  grease  fitting  located  on  the  gearbox  opposite  of  where  the  electric  motor
                     mounts.  This  fitting  is  there  so  the  shaft  bearing  can  be  greased,  because  there  is  not
                     enough splash from the ring gear to lubricate the bearing. It is recommended that one squirt
                     of a general purpose grease be applied every six months.



























































              22        Belanger, Inc. *PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681       1MANUL634
   21   22   23   24   25   26   27   28   29   30   31