Page 24 - Quad Wave Mitter Signature® Series
P. 24

QUAD WAVE MITTER Signature ® Series


             Installation

             Cleaning Material

                    1)  Mount the appropriate cloth panel onto each of the Waves as shown in the diagram on
                       the next page.
                    2)  Push the Mitter Wave up to hold the inserted cloth panels in place. Repeat this process
                       until all cloth is installed.
                    3)  Replace the bolt located behind the shaft bearing of the follower rack.
                    4)  Tighten the two loosened bolts, then the 1-1/8” top bolt. Rotate the tightening sequence
                       to achieve an even seating.
                    5)  Slide the outside collar back into position.
                    Note:  Split in collar MUST be perpendicular to the split of the shaft bearing halves.

                    6)  Return upper locking collar to its original position and secure it into place.
                    7)  Snug upper and outside collars tightly against both shaft bearings, and secure them into
                       place.
                    8)  Replace the rack connectors and all retaining pins.
                    9)  Repeat this process on the other side.





















































              20        Belanger, Inc. *PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681       1MANUL634
   19   20   21   22   23   24   25   26   27   28   29