Page 20 - Quad Wave Mitter Signature® Series
P. 20

QUAD WAVE MITTER Signature ® Series


             Installation

             Cleaning Material

             In  order  to  install  the  cloth,  some  disassembly  is  necessary.  Pay attention to how the machine is
             taken apart.
                    1)  Loosen the upper locking collar on the drive rack with a 3/16” hex wrench and slide it
                       over against the flat washer.
                    2)  Remove the retaining pin from the upper drive arm on the Pitman arm end and remove
                       the upper drive arm from the Pitman arm so that the rack hangs vertically
                    3)  Loosen outside collar using a 5/16” hex wrench.
                    4)  Slide outside collar out away from center approximately 4”.

                                                      Front View

                            1-1/8” bolt
                            (remove for cloth installation, typical)             Upper locking collar
               Outside

               locking collar                                                            Inside locking collar
               (typical)                                                                 (typical)










                    Shaft bearing


                                                                                          Inside end plate
                                                                                          (typical)



                      Outside end plate
                            (typical)



                          Cloth (typical)
























              16        Belanger, Inc. *PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681       1MANUL634
   15   16   17   18   19   20   21   22   23   24   25