Page 43 - H2AIR® Arch
P. 43

®
               H2AIR  ARCH


               Maintenance

               Trouble Shooting

                          Problem                   Cause                            Solution
                  Top Flip:                    No power                 Check power coming to Air Panel
                     Not Rotating              Controller program       Verify that the Controller has been programmed

                                               Air pressure             properly
                                               Cylinder airline connections      Check that  air  pressure  on  Air  Panel  has  been
                                                                         set properly
                                                                         Check airlines connections at the Air Panel and
                                                                         the Top Flip Cylinder
                  Top Flip:                    Incorrect air pressure      Adjust the extend and retract air pressure on the
                     Rotation Speed                                      Air Panel and/or
                                                                         Adjust the flow control valves on the extend and
                                                                         retract  ports  on  the  Top  Flip  Cylinder  to  obtain
                                                                         the desired rotation speed
                  Dryers:                      No power                 Check power coming to Motors
                      Not Working              Incorrect wire connections      Check  to  make  sure  the  wire  connections  are
                                               Controller program       correct in the Motor Electrical Box
                                                                         Verify that the Controller has been programmed
                                                                         properly
                  Dryers:                      Controller program       Verify that the Controller has been programmed
                     Turning On Late or                                  to turn on and off the dryers at the desired times
                     Turning Off Early
                  Airis®:                      No power                 Check power coming to Air Panel
                     Not Opening               Controller program       Verify that the Controller has been programmed
                                                                         properly
                                               Cylinder airline connections
                                                                         Check that  air  pressure  on  Air  Panel  has  been
                                                                         set properly
                                                                         Check airlines connections at the Air Panel and
                                                                         the Airis® Cylinders
                  Airis®:                   *   Air pressure settings      Adjust the extend and retract air pressure on the
                     Opening & Closing Speed                             Air Panel and/or
                                                                         Adjust the flow control valves on the extend and
                                                                         retract ports on the Airis® Cylinders to obtain the
                                                                         opening and closing speeds
                  Spray Manifolds:             Controller program       Verify that the Controller has been programmed
                     Not Spraying or                                     to turn water on at the desired time
                     Poor Rinse on Vehicle                               Verify Spray Nozzles are aligned properly
                  Spray Manifolds:             Nozzles clogged          Remove Spray Nozzles and clean with thin wire
                      Pulsating or             Kink in hose             Check all fittings on complete system to assure
                       Weak Spray              Inadequate water pressure   they are tight and do not leak
                                                                         Remove any kinks from hose
                                                                         Open water valve to fullest
                                                                         Call  Distributor  for  advice  on  installing  booster
                                                                         pump
                  LED Lights:                  No power                 Check electrical connections in Electrical Boxes
                      Not Turning On           Incorrect wire connections      Check Main Power connections
                                               Controller program       Verify that the Controller has been programmed
                                                                         properly
                                               Short in LED light assembly
                                                                         Replace LED light assembly
                  LED Lights:                  Controller program       Verify that the Controller has been programmed
                      Not Turning Off                                    properly



                 1MANUL958         Belanger®, Inc. *PO BOX 5470 *Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681     39
   38   39   40   41   42   43   44   45   46   47   48