Page 40 - H2AIR® Arch
P. 40

®
                H2AIR  ARCH


                Initial Startup Procedures

                Install Spray Nozzles & Verify Proper Function of Top Assembly and Airis®
                   7)  Actuate the 4-way valve on the Air Panel to activate the H2AIR® Top Flip Cylinder to verify the
                       travel of the Top Assembly.
                   8)  The Top Flip Cylinder will pivot the H2Air® Dryers and Top Manifolds as a vehicle moves through
                       the tunnel. The DryLite™ Air Cannon™ Nozzles will start at an angle of about 22° towards the
                       entrance of the tunnel as shown below.





                           H2AIR® Dryer Nozzles &
                          Top Manifold pivoted toward
                           the Entrance of the Tunnel





















                         Note:  The Top Assembly pivots from the entrance of the wash(see above) to the exit of the wash(see
                               below) with a total travel of about 40°.

                   9)  Then as the vehicle travels on the conveyor through the  H2AIR® Arch the Top Flip Dryers and
                       Top Manifold will pivot 40° and will have an end angle of approximately 20° towards the exit of the
                       tunnel, shown below.



                                                                                           H2AIR® Dryer Nozzles &
                                                                                          Top Manifold pivoted toward
                                                                                            the Exit of the Tunnel






















                   36     Belanger, Inc.® *PO BOX 5470 *Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681       1MANUL958
   35   36   37   38   39   40   41   42   43   44   45