Page 123 - Revit Architecture Basics

Stairs and railings

7. Draw a landing, there where the starirs are
ending.

Click Landing tool in Context Tab and use
Sketch Landing.

Draw a rectangle that follows the stairs
width (between the frames) which starts at
the last riser and ends at the front of the
slab on 1. Sal.

Click OK to the sketch and Revit will create
a Landing.
Also, stringer will be created automaticlly,
but stringers at the grid line D should be
deleted.

Use TAB to select it and press DELETE

8. Click OK again to exit the stairs and go to a
3D View, evt. using Section Box, where it
can be seen that the Revit has created
staircase.

9. It is possible to correct signature arrow so
that it corresponds to the Danish standard.

Select signature arrow and under
Properties select the type Fixed Up
Direction-Default

Adjust if necessary, further by clicking on
the Edit Type

 NTI 123