Page 17 - Foton Workshop Manual - Tunland (AT)

INTRODUCTION - GENERAL SERVICE GUIDELINE 01-11

(i) Use a Torque Wrench with Extended Handle 01
• When using a torque wrench with
special service tool or extended handle,
if the torque displayed by the wrench
reaches the rated figure, it means the
actual torque is excessive.
• In this manual, only the torque values
that require special notes are
described. When using a torque
wrench with special service tool or
extended handle, calculate the proper
torque based on the equation below.

• Equation:T＇=T×L2/（L1＋L2）

Torque reading
T＇
(N•m)
Actual torque
T
(N•m)

Length of
specialized tool or
L1
extended handle
(mm)

Length of torque
L2
handle (mm)

2 . Service Precaution on Model with Supplemental Restraint System
DANGER

Some vehicles are equipped with Supplemental Restraint System (SRS), i.e., driver
airbag. Failure to carry out service operations in the correct sequence may cause the
SRS to unexpectedly deploy during servicing, or even lead to critical accident.
Furthermore, an operational mistake may also prevent the SRS from normal operations.
Before servicing (including removal, installation, inspection or replacement of any
part), be sure to read through the following items carefully and perform the correct
procedures described in the service manual.

(a) General Precaution
• Since it is difficult to identify the failure of the SRS, Diagnostic Trouble Code
(DTC) is an essential source of information during troubleshooting.Thus, when
troubleshooting the SRS, always remember to check the DTCs before
disconnecting the battery.
• Operation can only be started 90 seconds after the ignition switch is turned to
the “LOCK” position and the negative (-) cable and the positive (+) cable are
disconnected from the battery. (The SRS is equipped with backup power supply.
Therefore, if any operation is taken within 90 seconds after disconnecting the
battery negative (-) cable and positive (+) cable, the SRS may deploy suddenly.)

Page 17