Page 1864 - Workshop Manual - Tunland (2017)

41-50 TRANSMISSION（JC538） - SECOND SHAFT ASSEMBLY

11 . Install the first gear assembly.
(a) Install the first gear needle bearing.
CAUTION

• When installed in the gear, the needle
bearing shall be no higher than the gear
end, or check the installation position or
replace the bearing.
• When installing the needle bearing, shake
it and check for missing needle. Replace
it in case of any damage.
• During installation, apply some lubricant
to the needle bearing, to avoid wear
caused by dry friction.

(b) Install the first gear assembly.

12 . Install the first/second gear synchronizer
41 assembly.
(a) Install the first gear synchronizer inner ring
module and the second gear hub circlip.
CAUTION

The synchronizer inner ring shall be installed in
the gear groove.