Page 493 - Wago_AutomationTechnology_Volume3_2015_US.pdf

6

491

System bus 1: RD+/TD+
Input Output 2: RD--/TD-- Block diagram of an output
3: TD--/RD--
4 4
1 5 3 3 5 1 4: TD+/RD+ Analog Output Supply
2 2 5: GND
Housing: Shield X1 ... X4
M12 B coded
M12
2
M12
2
Analoge Outputs 2: 24 V
X1 ... X4 1: Output +/-
4 4
1 2 2 3 +
5 5
4 3 1 4 5: Schield _ _ Ch Er
1 .. 4 1 .. 4
M12 A coded
3: Output - 1
4: 0 V U Logic
A
Housing: Shield 1 3
Error
F
Supply 1: 24 V U 3
Input Output 2: 24 V U LS 5
3: 0 V U A
2 2 LS
3 1 1 3 4: 0 V U A Module
4 4
mount
M12 A coded
Technical Data Technical Data
Analog value creation: Isolation: 6
Resolution 15-bit unipolar, Channel – Channel No
16-bit bipolar U LS , U A , system bus 500 V DC each
Monotonicity yes Configurable functions:
Cycle time approx. 1 ms Measuring range (per channel) 0-20 mA, 4-20 mA, ±20 mA, 0-10 V, ±10
Recovery time for resistive, inductive V, user-defined
and capacitive loads approx. 1 ms Substitute value strategy (per channel) Switch substitute value/hold last value
Failures and errors: Substitute value (per channel) 0 mA bzw. 0 V / substitute value according
Maximum continuous overload to measuring range
(without failure) 0 Ω Manual mode (per channel) On/off
Max. measuring error at 25°C ≤ ± 0.2 % of the measuring range Manual mode value (per channel) Value
Temperature error ≤ 100 ppm/K of measuring range Online simulation (per channel) Lock/unlock; simulation value: (according
Maximum error over the full to measuring range)
temperature range ≤ ± 0.6 % of the measuring range Online simulation (per channel/
Overshooting approx. ± 0.05 % of the measuring range module) Diagnostics
Output ripple approx. ± 0.02 % of the measuring range I/O diagnostics:
Crosstalk between the channels at I/O diagnostics (per channel) Short circuit (voltage)
DC voltage and AC voltage 50 Hz wire break (current)
and 60 Hz - 90 dB I/O diagnostics (per module) Short circuit/overload (actuator supply)
Short circuit protection electronic undervoltage (U LS + U A )
Nominal output current max. 1 A Process image:
System bus: Process data width 8-byte data + status
Connection type (3) M12 connectors, B coded, 5 poles, LED indicators:
shielded SB: System bus status LED (green/red/orange)
Standards and approvals: F: Error status LED (red)
Conformity marking 1 Ch1 ... Ch4 : Output signal status LED (yellow)
Korea Certification Er1 ... Er4 : Output signal error LED (red)
r UL 508 U LS + U A : Supply status LED (green)
Indicators Non-latching

General Specifications
Dimensions (mm) W x H x L 50 x 35.7 x 117
Weight 282 g