Page 9 - Parker - Process filtration

®
Clarifl ow General Grade

SPECIFICATIONS
Materials of Construction Performance Attributes
Membrane: Polyethersulfone Water fl ow rates, Typical*
Support layers: Polypropylene
Micron gpm/psid lpm/100mbar
Structural: Polypropylene
0.04 1.0 5.29
Effective Filtration Area 0.10 1.8 9.88
2
2
6.8 ft (0.63 m ) per 10” (250mm) cartridge
0.20 3.7 20
Maximum Differential 0.45 4.8 26
Pressure/Temperature 0.65 9.2 51
Forward: 0.80 9.5 52
80psid (5.5bar) at 75°F (24°C)
* Per 10-inch (250mm) cartridge equivalent with viscosity
40psid (2.8bar) at 180°F (82°C) of 1cP.
10-inch (250mm) cartridge
Reverse:
Water Flow Rate (lpm)
50psid (3.4bar) at 75°F (24°C)
0 8 16 24 32
5
300
4 0.04 m 0.10 m
Differential Pressure (psid) 3 2 0.20 m 200 Differential Pressure (mbar)

0.45 m

1 100
0.65 & 0.80 m

0 0
0 2 4 6 8 10
Water Flow Rate (gpm)
Ordering Information

25 — 10 — — G

End Fitting Nominal Length Filter Rating Gasket/O-Rings Gasket
Code Description Code Inches mm Code Micron Code Material Thickness
Code
0 DOE (Cuno ® ) 10 10 250 924 0.04 0 Buna-N Inches mm
1 DOE 20 20 500 001 0.10 1 EPDM 1 0.200 5
2 226/Flat 30 30 750 002 0.20 2 Silicone 2 0.125 3
3 222/Flat 40 40 1000 004 0.45 4 Viton ® (1) 0.200 5
4
6 020/Internal/Flat 006 0.65 FEP-Encapsulated (1) 0.125 3
5*
Viton ®
7 226/Fin 008 0.85 N No Gasket
FEP-Encapsulated
8 222/Fin 6* Silicone
N None
*O-Ring only

Specifi cations are subject to change without notifi cation. © 2010 Parker-Hannifi n Corporation
For User Responsibility Statement, see www.parker.com/safety domnick hunter Process Filtration - North America
All Rights Reserved
Clarifl ow is a registered trademark of Parker-Hannifi n Corporation
Viton is a registered trademark of E.I. DuPont de Nemours & Co., Inc.
Cuno is a registered trademark of Cuno Inc.
DS_IP_Clarifl ow G Rev. A
9