Page 71 - Parker - Fluoropolymer hose and fittings products

Hose Assembly & Crimping
PTFE Permanent Series 91, 91N

CAUTION: There are several different sections for Hose Assembly
and Crimping. Be sure you are in the section that corresponds to
the fitting series you are using. See Table of Contents for listing.

1 2 3

Cut Inspection Assembly Prep

Using a power hose cutoff saw, Hose – Visually inspect both Insertion Depth – Mark hose
cut hose squarely. ends of hose for square cut. end with proper insertion depth
Remove any burrs, loose fibers line. See Hose Fitting Inser-
or wires. tion Values, pg. 46 for insertion
depths of fitting series that do
not incorporate an insertion
Note depth. For covered PTFE hoses,
PTFE Hose should be taped use a sharp knife and light pres-
prior to cutting. Hose should sure to cut back the cover at
be cut at center point of taped least the length of the insertion
section. depth of the fitting.

Warning
Do not use lubricating oil when
installing fittings on hose used in
oxygen service. When installing
fittings on hose used in oxygen
service, lubricate with a non-oil
Fittings – Verify fitting series based soap solution. Failure to
corresponds to the selected do so may result in an explosion
hose. Visually inspect fitting(s) and personal injury when hose
for a through-hole, threads and is used.
damage.

Technical

Assemble hose – Push fitting
onto hose slightly and then
remove tape. Continue pushing
fitting onto hose until fitting
reaches depth insertion mark.

68