Page 74 - Parker - Fluoropolymer hose and fittings products

Catalog 5162F
Catalog 5162F

Hose Assembly & Crimping
PTFE Permanent PAGE Series

CAUTION: There are several different sections for Hose Assembly
and Crimping. Be sure you are in the section that corresponds to
the fitting series you are using. See Table of Contents for listing.

1 2 3

Inspection/Marking Cutting Assembly

Obtain correct hose, fittings and Using a rotary power cutting PAGE series fittings are not one
collars per customer order. Inspect saw with a smooth toothless piece but two pieces (insert +
to make certain no defects are blade, cut hose squarely to collar) and must be properly
present on fittings, collars or hose. proper length. Fitting length installed to assure leak free long
being used in the assembly shall life assemblies.
Using 1” wide filament tape, be taken into account when
apply 1 to 1½ wraps of tape tightly calculating hose length.
around hose at location to be cut.
Mark tape in the middle where cut
will be made. Tape will be left on
during crimping so only ½” width
of tape should remain.

Fittings – Inspect each com-
ponent for possible damage. In
addition, inspect socket and
nipple for a through-hole and
threads.

Blow ends of hose off / out to
remove any debris left from cut-
ting operation. Cut off wires or
fabric extending past the end of
hose.

Technical

71