Page 73 - Parker - Fluoropolymer hose and fittings products
P. 73
Hose Assembly & Crimping
PTFE Permanent Series 91, 91N
8
Measure & Inspect
Measure and verify hose assembly Inspect insertion depth mark at Measure crimp diameter of each
length. fitting ends. Insertion mark must fitting at top, middle and bottom
be visible but not exceed 1/8" of shell. Take measurements
from end of crimped fitting shell. at a minimum of three places
around shell circumference.
Verify crimp diameter is within
tolerances.
(Reference Crimp Source
Instructions, pg. 76 or Crimp-
source online at www.parker.
com/crimpsource)
Technical
70
