Page 111 - Condition Monitor User Manual

Viewing Measurement Data

higher priority than ‘ok’. This means that if some inputs from a single measurement
are reporting ‘error’ and some are reporting ‘clipped’, then the overall status is ‘error’.

Status Icon Meaning

The measurement status is ‘ok’.

One or more inputs shows a ‘clipped’ status. This means that the
raw EV signal is too large to read correctly.
One or more inputs is reporting a hardware error.

• The ‘Line Current’ column indicates the Line Current Operating Condition at the time
of the measurement. If Line Current was not available at the time of the
measurement, this will be blank. The measurement list can be sorted by this column.
• The ‘Temperature’ column indicates the asset Temperature Operating Condition at
the time of the measurement. If Temperature was not available at the time of the
measurement, this will be blank. The measurement list can be sorted by this column.

• The ‘Active Power’ column indicates the Active Power Operating Condition at the
time of the measurement. If Active Power was not available at the time of the
measurement, this will be blank. The measurement list can be sorted by this column.
• The ‘Reactive Power’ column indicates the Reactive Power Operating Condition at
the time of the measurement. If Reactive Power was not available at the time of the
measurement, this will be blank. The measurement list can be sorted by this column.

• The ‘Operating Point’ column indicates whether the detected operating point at for
this measurement was ‘FLH’, ‘FLC’, ‘RLH’, ‘Synchronized’ (the Shaft Trigger was the
correct speed, but the Operating Conditions were not correct for the other Operating
Points) or ‘Unknown’ (the Shaft Trigger was not at the correct speed, and the
Operating Conditions were not correct for the other Operating Points). The
measurement list can be sorted and filtered by this column.

Note:
Measurements collected from original GuardII and EVTracII monitors
will always have an ‘Unknown’ Operating Point.

• The ‘Comment’ column shows a User-editable comment about the measurement.

• The remaining columns show the Summary Number selected by the ‘Measurement
Parameter to Display’ selection described above. There is one column for each axis
in the database. The measurement list can be sorted by each of these columns.
Columns in the measurement list can be hidden, resized and/or rearranged as desired.
To select which columns to show:

• Right-click on the heading of any column in the list.

105
www.irispower.com