Page 45 - STARTER KIT ROOM ATTENDANT 2017v

STARTER KIT | HK-Room Attendant

Shower curtain has no mildew/ mold.
2. Empty and wipe trash can with dry rag. Replace plastic
liner if torn or with wet trash. T&B tiles should be clean, dry and shiny.
Scrubbing is done from the right side of the T&B clockwise or
3. Remove cobweb, stain and dust on the ceiling. counter clockwise to the left or right side of the door.

4. Flush the water closet, shake the water to mix sand and Toilet bowl is shiny white without stain streaks has no ring.
water sediments as flows. Toilet tank water level should be half or three fourths full.
There is no continuous flow of water from the tank.
5. Spray toilet bowl (around and under the lip area of the In scrubbing the floor, start from the farthest corner going out
bowl) with disinfectant, leave for ten (10) minutes while to the bathroom door.
attending to other task/s. Tub or Jacuzzi has no water marks, soap film and hair strands.
Start from the right or left side of the door from top to bottom
6. Pullout the shower curtain. clockwise or counter clockwise to the left or right side.
T&B fixtures are functioning well, do not leak, in correct
7. Scrub the wall tiles, faucet knobs, faucet, shower heads,
bidet shower, tissue and soap rack with all-purpose position, dry and spotless.
cleaner (APC) and scrubbing pad/foam. Glasses are clean, without smell, sanitized, dry, without
- Use rubber foam for marble. smudges and finger prints.
- Shower knobs and faucet
- Switches and plates
- Jacuzzi or bathtub
- Toilet bowl (seat cover and tank)
- Flooring
- Wipe both sides of the door with a damp clean
rag.

8. Wash the water closet surfaces down to the toilet bowl
rim and base.
- Scrub the outside surface of water tank and
toilet bowl down to the base using APC and
sponge.
- Scrub the inside of the bowl going down the rim
using toilet bowl APC and scrubbing pad.
- Clean the inside surface of the water tank using
APC and brush with handle.
- Flush the dirty water. Make sure all dirt is
flushed down also.
- Check toilet tank for clear water and water
level.
➢ Check tank for functionality, replace if broken.

9. Scrub the floor tiles and brush the drain strainer.
- Pay attention to grouts with mildew, soap marks
and stains.
- Remove floor drain, scrub and brush holes.
Brush the drain opening.

10. Rinse all washed facilities and amenities in steps 7 to 9
with warm water.

11. Flush the toilet bowl.

16