Page 85 - Regal ideas Binder_USA_v3

urbanrail ® Installation Instructions

Post Installation (UREP, URCP, URLP, URSP)

Identify where you will be With proper under-blocking At this stage, DO NOT Repeat these steps for your
placing your posts. installed fasten your post fasten your fasteners all the remaining posts.
in place with only 1 to 2 way into your base. Leave
Mark from the edge of the
deck 1″-2″ inward. This mark fasteners. fasteners loose, to allow posts TIP: Position and install
is where you will place the It is important you check with to tilt enough for top rails to be all corner posts first, then
edge of your post base. your local Building Depart- installed into top rail sleeves measure and center all
ment for approved fastener of posts. line posts.
IMPORTANT sizes for the deck you are
Post Spacing building.
should not exceed
6ft for glass and 8ft
for picket railing.

Pre-assembled Panel Installation (URTBP8)

Measure the distance between For Wall brackets or angle Mark and cut rails. Install gap cover on bottom
the posts at the base of the brackets, cut rails to length Use a handsaw or non- rail sleeves of posts before
post. so that rails will be fully ferrous aluminum cutting installing the bottom rails.
seated in rail sleeves on
When installing rails in posts, blade.
deduct 1/2” from this measure- brackets (no ½” deduction). Always wear safety
ment for cut length, to allow for glasses when cutting
inside welds of post sleeves.

Drill holes every 16” - 24” in Make sure to drill through Drop the bottom rail into the Level posts, then
underside of bottom rails for bottom and middle channel. bottom rail sleeves, then fully secure fasteners
water drainage, using a 3/16” tilt the top of posts to allow attaching posts to
diameter drill bit. Be careful not to drill top rails to slide into top rail substrate.
through top spacer sleeves.

regalideas.com/urbanrail | Toll Free: 1-800-819-4344 | Fax: 1-604-952-4291 | email: sales@regalideas.com 1
V2