Page 89 - Regal ideas Binder_USA_v3

urbanrail ® Installation Instructions

Angle Bracket Installation (URAB)

34 3/4”

Attach upper bracket with top Attach lower bracket with 34- Use URCS50 screws to Use URCS50 screws to
of flange touching post cap. 3/4” clear distance between fasten rails into top bracket. fasten rails into bottom
Use URCS50 screws to upper and lower brackets. bracket.
attach bracket into post.
TIP: Pre-drill using 1/8”
(3mm) drill bit.
Stair Railing Installation (Option 1: Post on stair tread)

The following installation is based on 36” Stair Rail height as measured vertically from the nose of the
stair treads, with a stair angle of 35 degrees (7.5/10.5 rise/run or equivalent). Measurements will vary
slightly depending on angle of stairs.

2 From mark to
top of square 3 Distance
bracket flange 35 1/2” 29” between
brackets

2 From mark to
top of square 3 Distance
bracket flange between
Position, level and secure brackets
What you will need: 36 3/4” 29”
posts to which stair rails will
• Stair Post attach.
• Stair Angle Bracket Posts must be level before 1 Mark post at height that
• Screws continuing the stair rail 35° stair tread nosing line
intersects with post.
• Top and Bottom Rail installation
• Stair Pickets

1 2 3

Take bottom rail and lay Measure from the marks Pre-drill and use URSC50 Measure from the underside
it across the stair tread made up 36 3/4” towards screws to attach bracket of the top bracket flange
nosing. Mark the bottom side the top of the post. flange at this height. down the post 29” and ,make
intersection of the rail and This is the position of the top Use a 1/8″ (3mm) drill bit size a mark.
post.
of the URSB Stair Bracket when using URCS50 screws. This is the position of the top
Install method shown is for flange. of the bottom flange.
35° stairs.

regalideas.com/urbanrail | Toll Free: 1-800-819-4344 | Fax: 1-604-952-4291 | email: sales@regalideas.com 5
V2