Page 88 - Regal ideas Binder_USA_v3

urbanrail ® Installation Instructions

Wall Bracket Installation (URWB)

Fastener Guide
Surface Screw Size Drill Bit Size

Aluminum #10 x 3/4” 1/8” (3mm)
42 1/2”
#10-14 x 1”
Brick/Concrete (Screw with Anchor) 5/16” (8mm)
5 1/2”
Wood #10 x 2 1/2” not required
Position upper bracket up Position lower bracket 5-1/2” Use appropriate fasteners to secure brackets to
42-1/2” from the floor to the from the floor to the top of surface.
top of the upper bracket the bottom bracket flange. Finish by attaching top and bottom rails to wall
flange. brackets using URCS50 (sold separately)

Picket Installation (URSP6, URSSP6)

Pickets
lock into A
place in seconds,
no screws
or bolts!

5/8" B

The key to the system Important to note that pickets A. If you HAVE NOT had to Start locking your picket into
are the patented “locking” are grooved on two sides cut your top and bottom rails, the bottom rail first and then
pickets. of each end of the picket. then you can start assembling snap into the top rail. You
your pickets starting from one will know when it locks into
Each picket must be installed The pickets lock the top
with the grooves parallel to and bottom rails together. side. place when you hear/feel the
the top and bottom rails in This eliminates the need for B. If you have cut your top and “click”.
order for pickets to interlock screws in the pickets bottom rails, then start from the TIP: Use a level to ensure
with rails center and move outward your pickets are placed
towards the posts symmetrically. straight when you begin.

As you are installing the pickets, It’s important that when you Snap in the top and bottom Cut last spacers as needed.

you will want to install the get to the end of a section spacers, and tap the picket
aluminum spacers. to put in the last four pickets snug next to it using a rubber TIP: Use a spare bottom
together. This will allow mallet. rail and snap in spacer.
Snap the aluminum spacer in This will keep the spacer
the bottom and tap the picket enough room for the final Spread pickets and snap on in place while cutting.
pickets to tilt in.
snug next to it with a rubber remaining spacers. Cut last
mallet. spacers to fit. Always wear safety
glasses when cutting
regalideas.com/urbanrail | Toll Free: 1-800-819-4344 | Fax: 1-604-952-4291 | email: sales@regalideas.com 4
V2