Page 32 - QR KLINDEX EXPANDER850AT-RXt

ASSEMBLY, TRANSPORTATION AND STORAGE

Adjusting the handle grip 5.1.3 Connecting the radio transmitter
To connect the radio transmitter (1) to the appliance
l NOTICE control plug(2), follow the instructions below:
To ensure better control of the appliance – make sure that the hooks(3) on the connector are
while it is in manual mode, it is recom-
mended that the handle grip is set to the open
height of the operator's hip. – angle the plug on the electrical cable so that it lines

To adjust the handle grip and set it to the required up with the pins on the connector (4)
height, act as follows: – insert the plug without angling it, as shown in the
– while supporting the handle grip, remove the cotter
figure
pin (5) followed by the pin (4)
– raise or lower the handle grip until the required 1

height is reached 43
– insert the pin (4) followed by the cotter pin (5).

4 1
5
2
BA

l NOTICE – after checking that the plug is fully inserted, close
Make sure that the pin is inserted fully be- the hooks (3).
fore starting any operation.

Handle grip positions

2

3
1

1 Manual working position www.klindex.com - Made in Italy
2 Working position with the radio control and dur-

ing interventions on the planetaries with the appli-
ance raised
3 Space saving position for storage and for working
with the radio control in areas with limited space

18