Page 35 - QR KLINDEX EXPANDER850AT-RXt

ASSEMBLY, TRANSPORTATION AND STORAGE

To move the appliance to the work area using the ra- Acting on the radio control:
dio control, act as follows: – insert the key
– check that the radio transmitter is connected to the – release the radio control emergency button by turn-

appliance control plug and that the battery in the ing it to the left
radio control is in place and fully charged.

Error B
Stop B
Error A
Stop A
RF Busy
Power
Working

STOP

– with the appliance battery energy supply, select – the display shows the message: “IMET Stand-by”
"Transport mode" by setting the main dial on the – press and quickly release the reset button to switch
electric panel to position "1", the "Transport Mode"
light activates on the radio control

OFF PLC GRINDING TRANSPORT * * * * * * * * * *IM* *E*T* * * * * * * * *
12 READY SP: * * * * * SHtzand-TBTy. * * * * *
POWER OK MODE SW: * * * * * OL: * * * * *

OK WB: * * * * * * * * * * * * * * *

LOW

– with the appliance connected to the mains power l NOTICE
supply, select "Grinding" by setting the main dial on If the reset button is pressed and held, the
the electric panel to position "2", the "Grinding pow- radio control will switch on in program-
er OK" light activates ming mode.

OFF PLC GRINDING TRANSPORT – the white Busy RF LED on the radio control receiver
12 READY starts to flash
POWER OK MODE
– the display activates
OK
**********************
LOW SP: * * * * * Hz TT. * * * * *
SW: * * * * * OL: * * * * *
– release the emergency button of the electric panel WB: * * * * * * * * * * * * * * *
by turning it to the right
– the white Busy RF LED on the radio control receiver
– the "PLC ready" light activates. stops flashing and stays fixed on, the red Stop LEDs
turn green and the Working LED activates
PLC GRINDING TRANSPORT
READY – the radio control is now fully operational.
POWER OK MODE

OK

LOW

www.klindex.com - Made in Italy 21