Page 123 - MRF Training TJ MRF Manual Version 5 22042024 final April 24_Neat

Cleaning Plant and Equipment

Osrel Truck wash and Equipment Cleaner will be available at each TJ waste site

This solution is used to remove concrete from ready mix vehicles and is a very strong
product as such the following procedures and safety advice must be followed to the rule.

The PPE required when using OSREL

Safety glasses and Full Face Visor

Paper suit (with high vis vest over the top)

Nitrile Gloves (Not general purpose gloves)
Dust Mask
Including all regular PPE

Procedures for use:

Put on the agreed PPE (above) and ensure that the site Foreman is made aware that you are
using OSREL.
Ensure that you use a large shallow bucket or drum that your long-handled brush can fit inside
easily without risk of tipping over during use.
Fill the shallow bucket to the level mark with clean water on a solid flat surface (the floor)
Remove cap from the OSREL TRUCK WASH and place the measuring jug on an absorbent mat
then measure the desired quantity of OSREL and pour into the water.
Dilution ratio of 70% water 30% Osrel is desired.
With a long-handled brush start to wash the machine, you will see this product eat into the
dirt, apply and brush then leave for a short while.
DO NOT LET THIS DRY ON THE MACHINE
You will have to wash and rinse with clean water after every couple of panels are covered
Continue around machine until the wash down is completed

Rinse whole machine again with clean water.
Dispose of paper suits after completion

If exposure to skin occurs during use, then wash immediately with plenty of clean water

Failure to follow these procedures will result in disciplinary procedures being taken
against you as we need to ensure you are taking care of your own and your colleagues’
safety.

Page 122 of 181

Reviewed April 2024