Page 19 - Chemical Tire Applicator™ / Wheel Brite Applicator™

CHEMICAL TIRE APPLICATOR™
WHEEL BRITE APPLICATOR™

Maintenance

Trouble Shooting

Problem Cause Solution

Mixture tank overflowing • Hydrominder float or chain • Ensure free and clear from any
interference obstructions
• Sticking needle valve • Replace valve (see replacement
parts)
No spray • Clogged foot valve on suction line • Check tank. If dry, system air must
be purged
No fluid in tank • Hydrominder float or chain • Ensure free and clear from any
interference obstructions
• No water supply • Insure proper float height is set
• Faulty Hydrominder • Repair or replace Hydrominder (See
Replacement parts or Hydrominder
section)

Pulsating or weak spray • Nozzles clogged • Remove cap with 1/4 turn counter
clockwise, remove strainer and clean
Pump not working • No air supply • Check air supply
• Pump can become airborne • Turn regulator knob counter
clockwise until zero pressure is
• Worn-out pump reached. Wait a few seconds and
turn back to operating pressure
• Replace pump (see replacement
parts)
Excess or zero air supply • Air pressure possibly too high • Reset pressure by turning counter
clockwise until pressure is below 20
• Parts in regulator may be sticking PSI, then back to operating pressure
due to moisture in system of 60-65 PSI
• Air regulator may be faulty • The regulator is equipped with an
automatic drain which will activate
when fluid is present. If fluid is
present in sight gauge
• Replaced air regulator (see
replacement parts).

1MANUL088 Belanger , Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 17