Page 1020 - 2006 HARLEY FLSTCI SERVICE MANUAL

7.6 4 d0411x7x 7-15
Figure 7-19. Pulling Mainshaft Inner Bearing Race

3
5 6

5 5 Figure 7-20. Push Rod Assembly 2006 Softail: Transmission

Bearing inner race Center disc Puller screw Retaining ring Thrust washer (2) Throw out bearing Oil slinger Push rod 4 2
2 2

1 Push rod end, left side

MAINSHAFT AND COUNTERSHAFT
d0344x7x 1. Leg 2. 3. Nut 4. 5. 1. 2. 3. 4. 5. 6. 3 1

SPECIALTY TOOL Bearing race puller and installation tool 4.11 EXHAUST SYSTEM: PRIMARY CHAINCASE HOUSING TOOL (Part No. HD-

NOTE Check the eight digit number stamped on the transmission case just above the side door. If the third digit is “9,” then the transmission was built for Japan only. If the digit is “0,” then it was built for all countries except Japan. If servicing a Japa- nese transmission, follow the steps under REMOVAL below and then see Appendix D.1 JAPANESE MAINSHAFT/COUN- TERSHAFT for disassembly and assembly instructions. NOTE Leave the transmission case on the frame unless the case itself requires replacement. For illustration purposes, some photographs may show the case removed. Remove exhaust system. See 4.9 EXHAUST SYSTEM: FXST/FLST/FLST

GENERAL REMOVAL PART NO. HD-34902-B SYSTEM: FXSTD/FLSTF, priate. chaincase. See 34902-B). speeds at the same time. nents as an assembly.

HOME 1. 2. 3. 4. 5. 6. 7. 8.

7