Page 1053 - 2006 HARLEY FLSTCI SERVICE MANUAL

8.8 2

1

3 Figure 8-11. CKP Sensor Assembly Figure 8-12. CKP Sensor

CKP sensor and O-ring Screw and captive washer CKP connector [79A]

s0274a8x 1. 2. 3. f2321x8x
CRANK POSITION SENSOR (CKP)

establish a reference point. The crank position sensor sends
a signal to the ignition control module which is used to refer-
wheel. Two consecutive teeth are missing in the flywheel to
Figure 8-11. The crank position sensor is a variable
reluctance (VR) sensor that generates an AC signal by sens-
ing the passing of the 30 teeth machined in the left side fly-
ence engine position (TDC) and engine speed.

1WARNING 1WARNING prevent accidental vehicle start-up, which could Disengage small end of slot on attachment clip from See Figure 8-11. Disconnect the 2-place Mini-Deut- Remove screw and captive washer (2) to detach CKP sensor and O-ring (1) from crankcase. Carefully remove

NOTE CKP sensor connector is not serviceable. If connector or sen- sor fails, the entire assembly must be replaced. cause death or serious injury, disconnect negative (-) battery cable before proceeding. (00048a) Disconnect negative battery cable. Detach wiring behind regulator bracket. T-stud on bracket. Lift connector off T-stud. sch CKP connector (3) [79]. NOTE Before removing wiring, carefully note wire routing. In particu- lar, pay close attention to the locations of cable straps which 2006 Softail: Electrical

GENERAL REMOVAL Remove seat. crank position sensor. must be replaced.

HOME See 1. To 2. 3. a. b. 4. 8-14