Page 1217 - 2006 HARLEY FLSTCI SERVICE MANUAL

der head (10). Gasket material left on sealing surfaces
See Figure 3-6. Remove old gasket material from cylin-
Wear

CAUTION Do not use glass or sand to bead blast surfaces exposed to the engine oil. Bead blasting materials become lodged in the pores of the casting where they cannot be removed through ordinary cleaning methods. Only after the engine is put into use will heat expansion cause this material to be released, and the resulting oil contamination will accelerate wear and lead to engine failure. If bead blasting must be employed, use walnut shells or other soft non-damaging abrasive that can be digested in the Be aware that bead blasting materials could also enter threaded holes adversely affecting fastener engagement and torque indication. Car

CLEANING 1. will cause leaks. ● engine oil. ● 2. 3. as necessary. 4. water. flow rates. (00061a) 5.

12 mm end

1 Figure 3-4. Cylinder Head Holding Fixture (Part No. HD-39786-A) 2 Figure 3-5. Valve Spring Compressor (Part No. HD-34736-B)

Holding fixture Cylinder head 1 Holding fixture Compressor 1 2 2006 FLSTFSE 2 : Engine

HOME 1. 2. 2 d0155x3x 1. 2. d0156x3x 3-6