Page 660 - 2006 HARLEY FLSTCI SERVICE MANUAL
P. 660

2-11





                          resulting in death or serious injury. (00290a)
                                           chamfered end facing away from wheel.  50-55 ft-lbs (67.8-74.6 Nm).  into top hole on fork leg.  bolt to 28-38 ft-lbs (38.0-51.5 Nm).  (38.0-51.5 Nm).

                11WARNING 1WARNING Be sure that brake fluid or other lubricants do not con- tact brake pads or discs. Such contact can adversely affect braking ability, which could cause loss of control, See Figure 2-6. If necessary, install brake disc in its orig- inal position. Verify that brake disc is clean. On left side of wheel, install five new screws (12) to attach brake disc (8). Tighten fasteners to 16-24 ft-lbs (21.7-32.5 Nm). Install hub assembly (2) or spacers (3, 7) with largest  Apply a light coat of LOCTITE ANTI-SEIZE LUBRICANT Place wheel into front fork and install axle. Verify that axle spacers on right and left side are properly installed. Instal















                                                  INSTALLATION  to the axle.       cap and slider is even.  (14.9-20.3 Nm).  a.   b.   c.   injury. (00284a)  pads.
                              4.         5.            1.    2.    3.                  4.    5.                                         6.

                     2.9 SEALED         1.8 BRAKE PADS                                                      2.10 WHEEL




              CLEANING AND INSPECTION

                     wheel bearings must be serviced, see   could result in death or serious injury. (00111a) Inspect brake rotor and pads. See   resulting in death or serious injury. (00290a)  If hub and rim were disassembled, see





                   Inspect all parts for damage or excessive wear. If sealed  11WARNING 1WARNING Always replace brake pads in complete sets for correct and safe brake operation. Improper brake operation  Verify that wheel and tire are true. See 2.13 DISC RIM  11WARNING 1WARNING Be sure that brake fluid or other lubricants do not con- tact brake pads or discs. Such contact can adversely affect braking ability, which could cause loss of control, See Figure 2-5. If necessary, install brake disc (9) and/or hub plate (6) in their original positions. Verify that brake disc is clean. Tighten fasteners to 16-24 ft-lbs (21.7-32.5 On left side of wheel, install five new screw




                       WHEEL BEARINGS.    AND DISCS.                                      attach left brake disc (9).   attach hub plate (6).  away from wheel.  LACED WHEEL.





          HOME     1.                   2.      ASSEMBLY  Disc Wheel  1.  RUNOUT.  2.  Nm).  a.   b.   3.  Laced Wheel  1.  RIM.  2.  3.  snap ring.
   655   656   657   658   659   660   661   662   663   664   665