Page 665 - 2006 HARLEY FLSTCI SERVICE MANUAL

2.19 FRONT BRAKE

Figure 2-11. Hub Cap Tool Install left and right hub cap seals (2, 24) and hub caps (1, 25) using HUB CAP REMOVER/INSTALLER (Part No. HD-41494). See Figure 2-11. Tighten until hub cap makes contact, then tighten 1/4 turn more. Install front brake caliper. See 11WARNING 1WARNING Whenever a wheel is installed and before moving the motorcycle, pump brakes to build brake system pres- sure. Insufficient pressure can adversely affect brake performance, which could result in death or serious Pump brake hand lever to move pistons out until they contact both brake pads. Verify piston location against

h41494 CALIPER: FLSTSC. injury. (00284a) pads.

3. 4. 5.

SPECIALTY TOOL Hub cap remover/installer Apply a light coat of LOCTITE ANTI-SEIZE LUBRI- From right side of wheel, insert axle through right spacer (4), nylon insert (5), O-ring (6), fender, right rocker (7), right side bearing spacer (8) and right CAUTION Place gray, Teflon-coated side of washer (15) against brake caliper mount. If washer is worn enough to show Continue through left side of hub, left side bearing spacer (13), brake caliper mount (14), washer (15), rubber spacer (16), left rocker (17), fender, O-ring (19), nylon insert (20) and left side spacer (21). 11WARNING 1WARNING Do not operate motorcycle without retaining pin (23) in

INSTALLATION PART NO. See Figure 2-10. Install axle. CANT to the axle (3). side of hub. brass underneath the Teflon surface, replace it. and nut slots. Install retaining pin. 2006 Softail: Chassis

HOME HD-41494 1. a. b. c. 2. 2-16