Page 666 - 2006 HARLEY FLSTCI SERVICE MANUAL
P. 666

2.9 SEALED                                  2.11 WHEEL                                                                             2006 Softail: Chassis
                            Inspect all parts for damage or excessive wear. If sealed
               2.7                                                                                                                                               2-17


                       CLEANING AND INSPECTION
                              wheel bearings must be serviced, see   WHEEL BEARINGS  11WARNING 1WARNING Always replace brake pads in complete sets for correct and safe brake operation. Improper brake operation could result in death or serious injury. (00111a) Inspect brake rotor and pads.  Minimum brake pad thickness: 0.06 in. (1.6 mm) or less above the backing plate. Minimum brake disc thickness is stamped on the side of the disc. Replace disc if badly scored. Maximum brake disc lateral runout and warpage is  0.008 in. (0.2 mm).  If hub and rim were disassembled, see   LACING: 21 IN. RIM. Verify that wheel and tire are true. See  2.12 TRUING  11WARNING 1WARNING B




















                            1.                   2.  a.   b.   c.    ASSEMBLY  1.  2.  LACED WHEEL.  3.      4.   ings.

                                        CALIPER: FXSTS. Support caliper using a rubber bun-
                                 Inspect wheel bearing end play and service bearings if
                                      Remove front brake caliper. See  2.20 FRONT BRAKE
                                                       2.33 FRONT FENDER:  Remove the axle locknut (15) and
                            Block motorcycle underneath frame so front wheel is
                                          gee cord. Be careful not to scratch the fender paint.
                                   necessary. See 2.9 SEALED WHEEL BEARINGS.
               FRONT WHEEL: FXSTS





                                             NOTE Do not operate front brake lever with the front wheel removed or the caliper piston may be forced out of piston bore. Reseat- ing the piston requires disassembly of the caliper.  Label wheel spacers for location (left or right) and orien- tation (fork side or wheel side). Place a towel under hub to catch any loose parts which Slide axle out of hub and rockers to remove front wheel.  NOTE See 2.14 TIRES to service tire or valve stem assembly. See Figure 2-12. Remove spacers (7, 12). If necessary, remove brake disc. Label components so they may be installed in their original locations. On left side of wheel, remove fi






                       REMOVAL  raised off the ground.  Remove front fender. See   FXSTS.  Figure 2-12.   See  washer (14). Discard locknut.  may fall from hub.  DISASSEMBLY  disc.




          HOME              1.   2.   3.               4.   5.   6.   7.   8.               1.  2.           rockers.
   661   662   663   664   665   666   667   668   669   670   671