Page 896 - 2006 HARLEY FLSTCI SERVICE MANUAL

cannot be rotated. If necessary, install shaft in vise
Verify that the thrust washer is locked in place and
using brass jaw inserts, and further tighten flange
3-109
2 4 2006 Softail: Engine
Figure 3-144. Rear Cam Roller Bearing Kit
bolt until the desired result is achieved. Remove flange bolt, flat washer, sprocket and CAUTION Always install new bearings. Only use genuine Harley- Davidson bearings. Reusing old bearings or using bear- ings from a supplier other than Harley-Davidson will Obtain the CAMSHAFT/CAMSHAFT BEARING RE- MOVER/INSTALLER (Part No. HD-43644). With the secondary cam chain side facing upward, place cam support plate on support block, so that outer races of bearings are properly supported. Note that one corner of the support block is contoured to accommodate the chain guide blocks cast into the front of the s

Thrust washer Roller bearing Bearing inner race spacer. result in engine damage.

O-ring
1
f1805x3x 3 1. 2. 3. 4. f. g. 3. 4. 5.

SPECIALTY TOOL Cam chain tensioner unloader Camshaft/camshaft bearing remover/installer CAUTION Always install new bearings. Only use genuine Harley- Davidson bearings. Reusing old bearings or using bear- ings from a supplier other than Harley-Davidson will See Figure 3-144. Obtain new rear cam roller bearing kit Install O-ring, thrust washer and bearing inner race onto To properly locate thrust washer (2), first install O- ring (1) in grinding relief groove. Groove is on the splined end between the machined area and the secondary cam sprocket. Exercise caution to avoid stretching or breaking the O-ring. Since the O-ring is not sold separat

Installation PART NO. HD-42313 HD-43644 result in engine damage. (Part No. HD-8983). rear camshaft as follows: a. a new roller bearing kit. properly centered. b. c. d. long flange bolt. fully install bearing inner race. e.

HOME 1. 2.